Ethernet Module (EI 80xF)
Ethernet module
EI 801F 10Base2 module, using thin coaxial cable
EI 802F AUI module, via receiver and transmitter
Transceiver can use coaxial cables
(10Base5), twisted pair cable, optical fiber cable
EI 803F 10BaseT module, twisted pair media or available
Use twisted pair or other media over the Hub
• The front panel has a status indicator and a battery voltage monitoring indicator
• Automatic module identification: the characteristic parameters of the module are present in each Ethernet module, and when the module is started,
These parameters are read out and processed, and after confirmation, the Ethernet module
Connection to the system bus in the AC800F is allowed
• The AC800F accesses Ethernet modules via the internal address/data bus, allowing maximum numbers
According to the data bus bandwidth can reach a maximum of 100MBytes/s
Each module can generate an interrupt, which is identified and processed by the system based on the priority of the interrupt
• One 8MB address domain on the module for memory access on the CPU, and another 8MB address domain
Shared to the fieldbus module
• The module allows 8-bit, 16-bit, 32-bit data bus access, depending on the configuration
• In order to ensure good contact between the module and the CPU board, be sure to lock the fixing screws on the upper and lower parts of the module.
The module automatically detects the connection, then sends the detection signal to the CPU, and the module is confirmed