IC695DEM008| IC695GCG001 |  IC695MDL664  | Ethernet interface module

Model: IC695DEM008

Category: Ethernet interface module

Finish: New/not new

Warranty: One year

Output quantity, type, and speed #N/A

Output rating #N/A

Current consumption #N/A

Organization UL, UL HAZLOC

Approved Area 2 CE, ATEX C1D2 ABS, BV, DNV, GL, KRS, LR

The media supports copper, MM, and SM optical fibers

Mounting on panel /DIN rail

introduce

Ethernet interface module IC695DEM008 is used to connect the PACSystems RX3i controller to Ethernet. it

Enables RX3i controllers to communicate with other PACSystems devices as well as the 90 Series and VersaMax

The controller. Ethernet interfaces provide Transmission control Protocol and internet Protocol (TCP/iP).

Communication with other control systems, hosts running programming software, and computers running programs

TCP/lP version of programming software. These communications use the Service Request Transport Protocol

(SRTP), Modbus TCP, and Ethernet Global Data (EGD) protocols pass through the Layer 4 TCP/iP(Internet) stack.

Features of the RX3i Ethernet interface include:

Programming and configuring services. Upgrade firmware from the RX3i CPU via Web/HTTP

If the CPU supports this method, or by using the WinLoader software utility, it provides updates

Ethernet interface software.

Periodic data exchange using Ethernet Global Data (EGD).

EGD reads and writes memory commands between the controller and EGD over the network

fCP/IP communication services using SRTP.

Support SRTP channels, Modbus/TCp servers and Modbus/TCp clients

Ethernet interface on the model panel for direct connection to the module.

3 since the sensing 10 baset basetx / 100/1000 basetx R | 45 shielded twisted-pair Ethernet port

Connect to 10BaseT or 100BaseTX or 1000T lEEE 802.3 networks without an external transceiver.

There is a network interface for the communication protocol and station manager (two ports) and one

A single interface (one port) is accessible only to the site manager.

Internal network switches with automatic negotiation, sensing, speed, and cross detection.

The Ethernet Restart button allows you to manually restart the Ethernet firmware without the need for a reboot

System.

led: OK, STATUS, LAN OK, LOG EMPTY, single port activity and speed led.

Independent redundant IP addressing can be configured, allowing a single IP address to be assigned

The corresponding Ethernet modules are in two different controllers. Redundant iP Addresses have been configured.

In addition to the normal unique lP address for each Ethernet module. Under application logic control, only

The Ethernet module of the primary unit can use redundant addresses.

Time synchronization to an Ethernet SNTp time server (when using a 5.00 CPU or later)

Module).