Model: IS200DTAIH1ACC
Category: Simplex analog input/output terminal board
Quality: New, not new
Warranty: 365 days
Stock: available
Brand: GE

Processor TMS320C6713B
The main frequency is 1GHz
Memory 128MB DDR2
External storage 256MB NAND Flash
Interface Ethernet, RS232, RS485, CAN bus
Operating temperature -40℃ to +85℃
Humidity 5% to 95%RH, non-condensing
Dimensions 100mm x 60mm x 22mm

【 Function Description 】

IS200DTAIH1ACC is a GE component created for the Mark VI system. Mark VI is a gas/steam turbine management system released under the Speedtronic family name. The series has been used in various iterations of turbine management since the 1960s. The Mark VI has Ethernet communication capabilities and includes on-board diagnostics (restricted checks) in both hardware and software.

The IS200DTAIH1ACC is a simplex analog input/output terminal board. It is a compact analog signal input board. The board is mounted on a plastic bracket that allows the PCB to be mounted on the din rail. The board has ten analog inputs and two analog outputs. The output is 0-20mA, but 0-200mA current can be configured by reconfiguring the jumper.

The IS200DTAIH1ACC features a single 37-pin connector and locking fastener. This is labeled JR1. The board has a terminal board (TB1) with 48 screws attached. The terminal tape is permanently installed on the circuit board. The terminal block generally uses shielded twisted pair of #18 AWG wire. Note that screws 43/44 are designated for ground (SCOM) connections. The ground cable should be as short as possible. The board has 21 jumper switches; These are labeled JP1A/ B-JP10A /B(20) plus JP0. The board also includes various capacitors, resistors, and integrated circuits, as well as four small sub-panels. Jumpers on the board are used to configure current and voltage.