DS200ACNAG1ADD | DS200SDCCG5AHD | Circuit board components
Model: DS200ACNAG1ADD
Category: Circuit board components
Warranty: 365 days
Stock: Yes
Communication protocol Modbus TCP/lP Modbus TCP/IP
Power supply :24V DC 24V DC
Operating temperature :-40°C to 70°C
Categories: GE
Tags: DS200ACNAG1ADD
Email:jllucky33@qq.com
phone:(86)17372046300
Product content
Model: DS200ACNAG1ADD
Category: Circuit board components
Warranty: 365 days
Stock: Yes
Communication protocol Modbus TCP/lP Modbus TCP/IP
Power supply :24V DC 24V DC
Operating temperature :-40°C to 70°C
【 Function Description 】
The DS200ACNAG1ADD is an ARCNET(Attached Resource Computer Network) card produced by General Electric for its Mark V series. The Mark V is part of GE’s successful Speedtronic family of gas/steam turbine management systems. The series has been managing heavy-duty turbine systems since the 1960s, with GE developing more reliable and advanced systems as technology allows. The Mark V has triple redundancy backup on all critical control and protection parameters and includes features such as built-in diagnostics and online maintenance.
The DS200ACNAG1ADD card provides a connection point for ARCNET LAN communications within the MKV system. The board signal is propagated on the channel between the main processor boards (LDCC), through the ARCNET board, to the turbine control operator interface, and back again. These signals travel through coaxial cables.
The DS200ACNAG1ADD is a small circuit board with very few components. The board has four metal film resistors (R1 to R4), three capacitors (C1 to C3), and a diode. The two factory drilled holes located on either side of the plate have a metal washer inserted into their opening. The two openings are labeled GND1/GND2. Two relays are located near the bottom edge of the board. Both relays have a relay diagram on the upper surface. A relay diagram is a visual representation of the relay logic that allows the relay to operate.
The DS200ACNAG1ADD has three communication devices. This includes a vertical pin terminal connector, with six pins, placed very centered on the board, and two BNC plugs (right angles, female), with openings placed on the top edge of the board. These plugs will accept LAN coaxial cable.
DS200ACNAG1ADD Frequently Asked questions
Does DS200ACNAG1ADD have a relay?
Yes, the DS200ACNAG1ADD has two relays. Both relays of the DS200ACNAG1ADD are 58614 relays.
How many BNC connectors does DS200ACNAG1ADD have?
The DS200ACNAG1ADD has two BNC connectors. The BNC connectors on the DS200ACNAG1ADD are labeled A and B.
Reviews
There are no reviews yet.