The IS200DTAOH1ABA is a microprocessor expansion board manufactured and designed by General Electric Company.
It is part of the Mark IV control system and can be used to add additional input/output (I/O) functions to the control system. Turbine control systems typically use microprocessors to control the operation of the turbine, and these microprocessors have a limited number of I/O pins, which can be solved by using microprocessor expansion board-1.
IS200DTAOH1ABA has the following characteristics: 1.
Features a single 37-pin connector and locking fastener. This is labeled JR1.
The terminal board is connected with 48 screws. The terminal tape is permanently installed on the circuit board.
The terminal block generally uses shielded twisted pair of #18 AWG wire.
There are 21 jumper switches. These are labeled JP1A/ B-JP10A /B(20) plus JP0.
The board also includes various capacitors, resistors, and integrated circuits, as well as four small sub-panels.
Jumpers on the board are used to configure current and voltage.
The IS200DTAOH1ABA is a simplex analog input/output terminal board with a single 37-pin connector and locking fastener 1.
The board has a terminal board (TB1) with 48 screws attached. The terminal tape is permanently installed on the circuit board. The terminal block generally uses shielded twisted pair of #18 AWG wire. Screws 43/44 are designated for ground (SCOM) connections. The ground cable should be as short as possible. The board has 21 jumper switches, these are labeled JP1A/ B-JP10A /B (20) plus JP0. The circuit board also includes various capacitors, resistors, and integrated circuits1.以上翻译结果来自有道神经网络翻译（YNMT）· 通用场景
逐句对照