8715-CA-BI | MTL831B | Analog signal isolation grid |

Product model: 8715-CA-BI
Product Category: Analog signal isolation grid
Finish: New/not new
Delivery time: from stock
Guarantee: One year
Express: SF Express/Debon
The 8715-CA-BI is an analog signal isolation gate designed to isolate and transmit analog signal MTL from 4 to 20mA
Basic parameters of 8715-CA-Bl:
Input signal :4-20mA DC
Output signal :4-20mA DC or 1-5V DC Isolation voltage :1500V AC
Frequency response range :DC-10kHz Linearity error :+0.1%
Power supply voltage :18-32V DC

Operating temperature range :-20°C to +60°C Mounting method: 35mm DIN rail Mounting Dimension :22,5mmx99mmx114mm Weight: about 160g
Functions and actual operation of MTL 8715-CA-BI:
Signal isolation :MTL8715-CA-BI can isolate the input signal, prevent interference between the input loop and the output loop, and ensure the quality of the transmitted signal
Signal conversion :MTL8715-CA-8I can convert 4-20mA analog signals into corresponding voltage signals, which is convenient for receiving and processing of various instruments, sensors and other equipment. Signal amplification :MTL8715-CA-B1 can amplify the amplitude of the input signal, so that the signal can be suitable
Should be longer distance transmission.
Signal protection :MTL8715-CA-8) The isolation and protection circuit is set between the input and the outgoing, which can protect the output device from the influence of overvoltage, overcurrent and other factors in the input circuit. Improve system reliability: The MTL8715-CA-B is highly isolated and protected
It can improve the reliability of the system, reduce the failure rate of the system, and extend the service life of the equipment
MITL8715-CA-B bus interface Block base Heat exchange The C1854A supports heat exchange, it can be switched online without causing any interference to other units connected to the CEX bus, and the single switch will be configured automatically after the handle is removed and subsequent insertion. Configure in several meetings
The backup unit can be replaced without interfering with the primary unit. This includes the ability to replace the device online if it fails, and no configuration is required in order to support heat exchange. Hot Configuration on the Run (HCIR) During hot configuration on the run, you can configure the slave device online
The C1854A supports heat exchange, it can be replaced online without causing any disturbance to other units connected to the CEX bus, after hot removal and subsequent insertion, the unit will be automatically configured, in a redundant configuration.
The backup unit can be replaced without disturbing the primary unit. This includes being able to replace the device online if it fails. To support heat exchange, no configuration is required.