8AC120.60-1| CAN interface | 5AP920. 15005-01 | 8LSA46.R0045D000-0

Model: 8AC110.60-2

Category: Plug-in modules

Finish: New/not new

Delivery time: from stock

Warranty: One year

Express: SF Express/Debon

Description:

CAN interface for installation in ACOPOS servo drives

For communication and configuration of ACOPOS servo drives in standard applications

The node number can be configured using switches

ACOPOS plug-in module, CAN interface

CAN interface is a widely used real-time communication serial bus standard, its characteristics and main applications can be summarized as follows:

The basic principle of CAN interface

Broadcast communication mode: The 8AC120.60-1 CAN bus adopts broadcast communication mode, which means that each node in the network can receive all data messages transmitted on the bus, but each node can intelligently filter and only respond to its related messages.

Differential signal transmission: CAN transmits data using differential signals, that is, opposite signals between CAN_H and CAN_L, to reduce interference and improve anti-jamming capabilities.

Message type: 8AC120.60-1 The CAN standard defines four different message types, including data frame, remote frame, error frame, overload frame. Packets use a bit-by-bit arbitration intelligence scheme to control access to the bus, and each packet is marked with a priority.

2. Physical layer interface of CAN interface

The physical layer interface of a CAN interface comes in many forms, including but not limited to the following:

DB_9 interface: The most commonly used 9-pin D-Sub connector in the general industry, where pins 6 and 9 are also commonly used as input pins for the power supply voltage of CAN devices.

OPEN_5 Terminal interface: The Open_5 interface is defined. The number of pins used may vary depending on the actual situation.

M12 terminal interface: An interface definition in the form of M12, which may include 5pin, 8pin, 9pin, 10pin, and 12pin interfaces.

Multi-p Phoenix terminal type: This is a versatile CAN interface type.

3. Application scenarios of CAN interface

The 8AC120.60-1 CAN interface has a wide range of application scenarios, including but not limited to the following aspects:

Automotive electronic system: Each subsystem in the vehicle, such as the engine control unit, braking system, air conditioning system, etc., CAN communicate and exchange data through the CAN bus interface, thereby simplifying the system architecture and improving reliability.

Industrial automation: Each device in the industrial control system, such as PLC, sensors, actuators, etc., CAN also be connected and communicated through the CAN bus interface to achieve high-speed data transmission and fast response to meet the application needs of high real-time requirements.