The GE SHunt connector board DS200SHCBG1A has a 2-pin connector and two terminals for bridging and motor signal connections. When replacing the GE SHunt connector board DS200SHCBG1A, you must disconnect three wires from the old board and reconnect them to the replacement board. The best practice is to create a label for each cable and wrap the label around the cable, or use a sticker that can be pressed onto the cable to attach it. To disconnect a 2-pin cable, use one hand to prevent the board from moving and use the other hand to grab the cable connector and pull it out of the board connector.

To disconnect the bridge and motor cables, use a wrench or other hand tool to loosen and remove the nuts from the terminals. Slide the cables out of the terminals and move them out of the work area. Then, slide the cable over the terminal and secure it with a nut. Use a hand tool to tighten it enough to fit snug against the terminal. Over-tightening the nut may cause the terminal to break.

The DS200SHCBG1A connector board is a circuit board for connecting electronic components.

The DS200SHCBG1A connector board is an electronic component commonly used to connect circuit boards. It comes in a variety of different types and specifications, which can be selected according to different application requirements. Connector boards play an important role in electronic devices, ensuring stable connections between circuit boards and improving system reliability and stability.