DS200TCQCG1BGF | Overflow plate | It consists of 24 jumpers and 3 40-pin connectors

DS200TCQCG1BGF technical specification

Manufacturer ge General Electric

Series mark V

Part number ds200tcqcg1a

Product Type rst overflow board

Product description

The GE RST overflow board DS200TCQCG1BGF consists of 24 jumpers and 3 40-pin connectors. It also has three 34-pin connectors and one 16-pin connector. The ID assigned to the 16-pin connector is JC. The ids assigned to 40-pin connectors are JFF, JE, and 6PL. Jumpers on the GE RST overflow board DS200TCQCG1BGF enable the installer to configure the board according to the exact requirements of the device. When installing the original board, the installer will review the information in the installation guide provided with the board. It contains a description of the jumpers and how the position of the jumpers changes the way the board is handled. In consultation with facility engineers, installers can set up jumpers to better meet the requirements of the facility. This is part of the drive installation process and may require some pre-installation communication between the installer and the factory representative to decide how best to set up the jumper.

However, once completed, the jumper remains in place and no further configuration is required. This is especially useful when you plan to replace a board that is defective due to an installed board. The only configuration required is to set the jumper on the replacement board to match the jumper position on the old board. To do this, place the old board on a flat, clean surface. Then wear an ESD wrist strap and take the board out of the sealed ESD bag. Place the board next to the old board and compare the jumper position.

DS200TCQCG1BGF Frequently Asked Questions

Which boards do DS200TCQCG1BGF need to operate?

In order for the DS200TCQCG1BGF to work properly, the DS200TCQCG1BGF requires TCQA and TCQB.

How many DENET connections does DS200TCQCG1BGF have?

The DS200TCQCG1BGF has two DENET connections and establishes a six-port passive bridge for the DENET.

What does DS200TCQCG1BGF bring to the LVDT?

The LVDT requires the driver voltage provided by the DS200TCQCG1BGF.

What conversion on DS200TCQCG1BGF?

The digital to analog conversion of high speed mark v control system is realized on DS200TCQCG1BGF. This conversion done by the DS200TCQCG1BGF represents the required fuel flow.