G123-815V001 | buffer amplifier | Standard interface PLC analog input/output module

Model: D136-001-008
Category: Buffer amplifier
Finish: New/not new
Delivery time: from stock
Warranty: One year

1 Range

These application notes are a guide to applying G123-815

Buffer amplifier. They will show you how to install, connect and adjust the buffer amplifier. They don’t tell you how to design a closed-loop system that uses it.

2 Description

G123-815 Standard interface between buffer amplifiers PLC analog input/output module, side, side

At the other end are the position sensors and Moog valves. It simplifies the use of PLc in closed position loops

The buffer amplifier solves a common problem in the circuit +10V PLc output is incompatible with wave drive requirements. It also provides the valve with digital noise filtering for the signal and noise filtering of the position sensor signal. See the Moog Manual for more detailed instructions

g123-815 e01.01.

3 Installation

3.1 Location

A horizontal DlN rail, mounted on… Vertical back surface

An industrial steel housing is a predetermined method

More and more. G123-815’s derailment card should be facing forward

Down, so the front panel and terminal ID are

Readable, so the internal electrons receive cooling

Airflow is an important consideration for placement

Modules are electromagnetic interference (EMl) from others

The device inside the enclosure. For example, Vf and AC servo

The drive can produce high levels of EMl. Always check EMC

Before placing the G123-815, check other devices for compliance

It’s nearby.

3.2 Cooling

Vents on the upper and lower sides of the G123-815 housing

Provides cooling for internal electronics. These vents should be

Stay awake. It is important to ensure the equipment below

Does not produce the hot exhaust that heats the G123-815