Model: LD800HSE
Foundation fieldbus connection device
Provides links between FF’s High Speed Ethernet (HSE) protocol and up to four H1 links
Configure connected H1 devices transparently from the host system
Allows access to blocks in H1 devices (client/server)
Four independent H1 Link Master Stations (LAS)
Publish/Subscribe (H1) (up to 4 sub-cycles)
Republish data from one H1 link to another H1 link or from H1 to HSE
Firmware update via download.

The LD 800HSE link device acts as a gateway between the field device on the H1 link and the HSE subnet.
The LD 800HSE allows access to field equipment connected to the Foundation Fieldbus (FF) from the monitoring system as well as the management console. The device qualifies for redundant use, where the corresponding H1 ports of two linked devices are connected to one H1 link. Independent redundant links between primary and secondary connected devices ensure reliable failover and redundancy monitoring.

There are two different versions available, one for safe areas and one for dangerous areas.

dimension
(L x H x W) : 47 x 131 x 111 mm,
Mounting on DIN rail 35 mm
Weight: About 0.4kg
Protection level: Protection level 20
Environmental condition
Operating temperature: 0° C… +55° C,
Non-vertical mounting and blocked air
Convection may lower the upper temperature limit
Storage temperature: −20°C… +70°C
Relative humidity: 0%… 95%, no condensation
Ethernet interface

Number of channels: 1
Port: Ethernet 10BASE-T/100BASE-TX, TJ45
Transfer rate: 10 Mbit/s or 100 Mbit/s (automatic sensing)
H1 Field bus interface: Number of channels 4
Port FF H1 3-pole screw terminal (pluggable),
Transformer coupling: electrical isolation
Physical Layer Profile Type 114, standard power signal, separate power supply, not intrinsically safe
Transmission rate 31.25 kg bit/s
Serial port 9 pole SubD male RS-232,115.2 kbit/s
Certified to comply with CE Directives 2004/108/EG (EMC), 2006/95/EG (Low voltage) and 94/9/EG (ATEX)
Electromagnetic compatibility (EMC). FCC Part 15 B Subpart A,
VCCI Category 2 Information Technology Equipment 2002
Shock and vibration, according to DIN IEC68 Part 2
G3 coating, compliant with ANSI/ISA 71.04, EN60068-2-60
Certified (LD 800HSE EX only)
Hazardous Place Certification:
UL Class I, Zone 2, A, B, C, D
Group IECEx Ex nA IIC T4 Gc
ATEX II 3G Ex nA IIC T4 Gc