Three steps to solve the filter press filter shortage

With the promotion of environmental protection awareness in various industries and the requirements of environmental protection departments. Filter press has become the preferred equipment for wastewater sludge treatment in most industries. Today, Beibon Environmental Protection will share with you some occasional situations and solutions encountered in the use of filter press.

Reasons for insufficient pressure of filter press; Filter press hydraulic pump motor out of phase operation, pressure regulator regulation is not in place or regulation failure. In view of these three reasons, we can take corresponding measures to solve.

First check whether the motor of the filter press is in good condition and whether there is overheating operation. If the motor is damaged, the wiring terminals, cables, thermal relays, contactors and other parts of the motor should be checked one by one along the load circuit of the motor until the cause of the fault is found, the fault is removed and the damaged motor is repaired. If no motor problems are found, consider whether the regulator is in good condition.

Pressure regulator failure causes such failures: 1, the rated pressure of the pressure regulator is improperly adjusted; 2, the adjustment bolt is too tight or the exhaust hole is blocked by foreign matter or the selection of improper products; 3. The seal is damaged and the seal is not tight, or the valve port and valve have foreign bodies.

The solution to the pressure shortage caused by the failure of the pressure regulator is as follows: 1. Adjust the adjusting bolt of the pressure regulator (screw the bolt downward and increase the working pressure); 2, check whether the bolt is adjusted too tight, dredge the oil drain hole on the valve body; 3. Replace the oil discharge valve seal or disassemble and replace the inlet and outlet valve disc.

The above is the three-step solution to the insufficient filtration of the filter press shared today, remember that in the case of insufficient pressure, the filter press can not work normally, which will affect the advancement of the work process. In order to prevent insufficient pressure from affecting the normal work of the filter press, we should pay attention to these problems in regular inspections. After the purchase of Beibang environmental protection filter press equipment, in the normal use of the process encountered their own failure to solve, you can call us directly, our maintenance team will be the first time to help you solve the problem.